1、墙纸裁剪

1, wallpaper cutting

按照壁纸的流水号将壁纸摆好，量取墙体的高度，根据墙体的高度上下各预留5公分进行裁切壁纸，切记一次裁切一卷壁纸，以防出现品质问题。

The wallpaper wallpaper set according to the serial number, amount of wall height, the height of the wall according to the reserved 5 cm cut wallpaper, remember a cutting a roll of wallpaper, in case of quality problems.

2、墙面处理

2, metope processing

墙面要求平整、清洁、干燥，颜色均匀一致，应无空隙、凸凹不平等缺陷，施工前墙面要做刷基膜(或清漆)处理。

The wall must be smooth, clean, dry, uniform color, should be no gap, uneven concave and convex defects, before the construction of the wall to brush the basement membrane (or varnish) treatment.

3、刷墙纸胶

3, brush wallpaper glue

贴无纺布壁纸胶水必须均匀地刷在墙面上，厚度在2mm即可，绝不可将胶水直接刷在无纺布的背面，更不可泡水湿贴。无纺布与其他壁纸不同，应比其他壁纸的胶水较浓、厚，使其流动性下降。

Sticking non-woven wallpaper glue will be evenly brush on the wall, the thickness of 2mm can be, will not be the glue brush directly on the back of the non-woven fabric, more can not be soaked in water wet paste. Non woven fabric and other wallpaper, should be thicker than other wallpaper glue thick, so that its mobility decreased.

4、贴墙纸

4, wallpaper

按照事先比对好的顺序对无纺布墙纸进行张贴。

Posting the non-woven wallpaper according to the good order in advance.

5、施工墙纸裁切

5, construction wallpaper cutting

需要搭边对裁施工，具体方法是在施工时搭边，搭边多少依花型而定，大约在3公分左右，素色无纺布在施工时采用正反贴的方法施工，对花型号在确保花型对齐后，在重叠处用直尺压住，进行裁切，尽量避免在阳角处裁切，以免引起阳角处壁纸翘边，在裁切时确保裁刀锋利，不可有毛边，同时注意下刀的力度，要保证一次裁剪、一刀两断，但是还不能过分的伤到墙壁的表面。

Need to take the edge of cutting construction, the specific method is in the construction of edge edge, according to how flowers may be, about 3 centimeters, the construction method in the construction of a positive plain cloth paste, to ensure the flower model in the flower type aligned, cutting ruler is pressed at the overlap, as far as possible to avoid the positive corner cutting, so as not to cause Yang corner wallpaper Alice, make sure to cut blade when cutting, no burrs, and pay attention to the knife efforts to ensure a clean break, cut, but the surface can not be too hurt to the wall.

6、墙纸贴后清洁

6, wallpaper paste after cleaning

施工完后若表面有灰尘，应用短毛刷或掸子轻拂，不可用湿毛巾擦拭造成污染扩大。

If there is dust on the surface after the construction, application of short brush or duster blows, not available wet towel to wipe the pollution caused by the expansion of.